Comments on: Make a 12 VDC power supply for RC LiPo Battery Chargers.

By: snuckz8

snuckz8 — Thu, 27 Sep 2012 05:23:40 +0000

nice video.I have bought a f-20 that works with a li po 11.1v battery . the problem is that im trying to charge it with the specified charger but it wont charge only a red light [power] is on .the green light doesnt come on .its a winsky 501bc charger .is there any other way i can charge this? battery . where im from ,i cannot get another battery r charger n to oder it will be very expensive

By: how367

how367 — Thu, 27 Sep 2012 04:45:05 +0000

I would like somethink this to be used for car sterio amps
to pump out 500 watts of amps to to the preamp
To make? A portable car sterio / computer setup Big Box

By: jsquid526

jsquid526 — Thu, 27 Sep 2012 03:54:23 +0000

why don’t you just buy a laptop or monitor 12v power? adapter capable of 5A, much lighter than a power supply let alone a 60lb car battery,

By: KaldekBoch

KaldekBoch — Thu, 27 Sep 2012 03:50:22 +0000

Much more than 5 amps? is needed for lots of the chargers these days. Most PC power supplies will give you 10 amps on the 12 volt circuit.

By: marhar2

marhar2 — Thu, 27 Sep 2012 03:48:59 +0000

Thanks for posting! Would it? be possible to trim or remove all the excess wiring, so the only wires would be the 12 volt and ground?

By: marhar2

marhar2 — Thu, 27 Sep 2012 02:50:05 +0000

Does the single yellow wire carry the 10 amp 12 volt load OK? (without heating up?) Could two yellow wires (from different harnesses) be attached together if necessary?

By: psygn0sis

psygn0sis — Thu, 27 Sep 2012 02:00:16 +0000

Yes, it is preferred to wire 2 or more yellow? leads in parallel to carry the voltage.

By: psygn0sis

psygn0sis — Thu, 27 Sep 2012 01:08:21 +0000

Yes!?

By: heldgop

heldgop — Thu, 27 Sep 2012 00:24:49 +0000

current ;D?

By: psygn0sis

psygn0sis — Wed, 26 Sep 2012 23:38:12 +0000

Correct. lol thanks! ?